How To Install Laminate Flooring

Preparing the Floor

If you've got another type of flooring, this is the time to get rid of it. Pull up your old carpet and padding. Remove all of the tack strips around the room's perimeter. You may need to scrape the floor to get rid of any padding sticking to it. Vacuum it well. If there are any noticeable dips, level them out. On a concrete slab, thinset or another self-leveling compound may be skimmed on it.

Repair Plywood Sub Flooring if applicable.
Remove the baseboards. You may be able to save these if you are careful. Now use the coping saw to cut off the bottoms of door jambs, case openings, etc. This will probably be 1/4” to 3/8” dependent on the combined thickness of the laminate and underlayment pad. It is recommended to buy the thicker pad; it is well worth the added expense.
In order to know how much laminate flooring and underlayment pad to buy you will need the square footage. To get this simply measure the area's footage right to left and then forward and back. Multiply those figures together and that is your square footage. It is prudent to add at least 5% to that figure for scraps.

Install your laminate flooring


The first thing to do is roll out the underlayment pad. Connect the pieces together with wide, clear, plastic tape. How your laminate planks connect depends on the brand you buy but they are all rather simple; most simply snap together. Remember to stagger the joints.
Laminate flooring is a type of “floating floor”, meaning that it is all connected to itself but not to the house. With this in mind, leave 1/4” clearance at each wall. On the initial wall where you start, use spacers that you can pull out before installing the baseboards.
As you go along you will need to use your mallet and pull bar to snug things up. A few gentle taps will do.
Things will get tricky as you go through doorways; the manufacturer's instructions most likely will not tell you about this because it impedes sales to DIY'ers. In some circumstances the best solution is to use your utility knife to trim the snapping connections on the adjoining planks so that they can slide together. In this case, use a few drops of wood glue to keep them together.

Finishing up - Install the Baseboards


Once you're done with installing the laminate flooring planks you can get on your baseboards. If you've been careful with the removal you can reuse them. Otherwise, Cut And Install New Baseboards. Miter and caulk all joints. Remember not to nail into the planks – this is a floating floor. If you find you have cut some planks too short and the baseboard doesn't cover adequately, don't fret; just install quarter-round at the floor line.
Make sure to understand How To Care For Laminate Flooring Now that you're done, step back and admire your work!


Source   Kelly Smith